Inception Designs Rear Stop / Autotrigger Plug used but looks the part of

but looks the part of the kit as well

Weight (oz): 15oz

Shaft FL Carbon Fiber barrel tip (produced in collaboration with DeadlyWind)

rate of fire:12 rds

Ambidextrous slide stop

Inception Designs Rear Stop / Autotrigger Plug used but looks the part ofThis is a plug for an Inception Slide frame that has the Autotrigger hole in the frame. This plug allows you to fill in the hole when using the frame on an Autococker rather than a pump Sniper. This will ONLY fit our frames with a sliding trigger plate. It will not fit our pivot frames or other manufacturer's frames. This can be used with a small set screw to adjust the rear stopping point of the trigger, but that's quite fiddly so we don't recommend